Says bottu at ben.vub.ac.be
>>Some GCG programs need two sequences as input, e.g. the comparison
>programs gap, bestfit and compare. Sometimes, one wants to compare
>a sequence with itself. At the command line, it is easy : GCG
>proposes the first input sequence as default for the second sequence.
>With the WPI it was easy too, you could just click on "Select...". With
>SeqLab however, this has become impossible. The only way I found is
>cumbersome and involves putting twice the same sequence in the List File
>in the Main List. Anyone a comment ?
>> Dr. Guy Bottu,
>
I have made the same observation loudly to GCG.
I'm kinda wondering when they are going to publish all the bugs and
annoyances that have been found so far.
Others:
an entry in the main list may look selected but is not.
Profilescan can mess up big time if more than one sequence is searched.
--- that's all I have time for now folks.
Nick Staffa
National Institute of Environmental Health Sciences
RTP NC
