I can't get gelmerge to run successfully from WPI. All job manager output
says that it ran successfully, but it never merges anything. I can create
a project with gelstart and enter the fragments with gelenter (although
both gelenter and its homolog seqed cause enormous core dumps under WPI,
they seem to function just fine otherwise). Even if I start the project
from command line and then switch to WPI, gelmerge doesn't merge the
fragments.
If I switch to command line, I can merge a project that I started under
WPI, then switch back to WPI and everything works fine. I can even run
dissasemble under WPI on that project, but then I can't reassemble the
fragments with WPI gelmerge. In all cases, I'm running default settings
on a set of 16 overlapping fragments that I created artificially from a
known sequence that I'm working with.
Can anyone offer advise on how to fix this?
GCG v 8.0.1 UNIX under Solaris 2.3.
-David
--
David D. Womble
Center for Molecular Medicine and Phone: 313-577-2374
Genetics, Wayne State University Fax: 313-577-6200
5047 Gullen Mall, Detroit, MI 48202 E-mail: dwomble at cmb.biosci.wayne.edu
