In article <47k29h$hgp at morgoth.sfu.ca>, cooch at fraser.sfu.ca says...
SIGMA-PLOT
>I just purchased the upgrade to 3.0. However, I have noticed that it has
>one major problem (at least for me) - it absolutely refuses to print on
>my HP 4M PostScript printer. Has anyone else out there who has
upgraded
>had this problem? I'm on the verge of sending it back.
Well I'm using V1.02 and have had no printer problems until I installed a
new HP 850C - Now the output is screwed up totally :-( I have no idea
what causes this problem as the printer behaves fine otherwise. If I try to
print across the network onto another printer (BJ-200) the output is also
screwed up. However, if I go to the machine to which the BJ-200 is
attached and open up the *.spw file (still on my machine in a shared dir) I
can output fine.
I'd be grateful for any inout on this.
>I might even be willing to ignore the fact it takes 45 seconds to just
>load it on my hot-rod machine if I could get it to print! :-)
Mmmm - Slow is it :-( - I'm thinking of making the upgrade to 3 recomend
it?
========================================================
Bob Lauder
Biological Sciences,
University of Lancaster, UK
Home page - http://bssv01.lancs.ac.uk/gig/ppl/bob/home.htm
